Silage Shear Grab

Challenge silage shear grab design and features

Fit your compatible front-end loader to a Challenge silage shear grab and cut silage blocks from a silage pit, leaving a smooth face that is sealed to prevent spoilage. The rounded front profile of the grab is forced through the silage in a circular motion, reducing the cutting force required and ensuring an efficient, clean cut. The Challenge silage shear grab attachment comes in two sizes with a bunch of features.

  • The ability to cut silage into blocks leaving a smooth face that is sealed to prevent spoilage
  • Hardened serrated front knife and hardened plain knives on the sides for accurate silage cutting
  • The two heavy-duty hydraulic cylinders provide ample cutting force and the attachment is fitted with quality heavy-duty tines to accommodate this
  • Comes in two widths, see specifications for the finer details
  • The tines are spaced to ensure wastage from material being handled stays confined inside the attachment
  • All tines fit into a tapered sleeve and are removable
  • Available in two hitch types; Aus and Euro

Electric third service required…

The Challenge silage shear grab requires a third hydraulic control circuit to activate the grab/cutting portion of the attachment; the electric third service feature comes standard with the Challenge CLX™ series front-end loaders.

Challenge silage shear grab specifications

Please swipe the table to read all data
Model 140SS 170SS
Weight 370 kg 460 kg
Width 1400 mm 1700 mm
Depth 880 mm 880 mm
Volume/capacity 0.81m³ / 498kg 0.98 m³ / 602 kg
Maximum opening 730 mm 730 mm
Compatible bottom tines x usable length 9 x 670 mm (Conus I) 11 x 670 mm (Conus I)
Compatible bottom tine spacing 125 mm 129 mm
Compatible side tines x usable length 2 x 670 mm (Conus II) 2 x 670 mm (Conus II)
Compatible side tine spacing 125 mm 129 mm

Challenge silage shear grab can be used on Aus or Euro hitch front-end loaders